The CMT Forstner bit (537-450-31) is used to drill precise flat bottom holes with no chipping in any softwood thickness.
TIPS AND WARNINGS
Making repeated shallow cuts and allowing the bit to cool for two or three seconds between passes will increase the life of your bit. Overheating caused by chip buildup or constant contact with the cutting surface will remove the temper from the bit’s cutting edges.
You can also extend the life of your bits by not exceeding the maximum speed recommended for the type of wood. Applying excessive force to the bit while drilling will also cause overheating.
Remove all the chips from the previous hole before boring a second or subsequent hole when mortising.
Small Forstner bits can be used in a hand drill, but the results are usually less than satisfactory. Using bits larger than 19mm (3/4”) in a hand drill can cause injury when the bit hangs on an imperfection in the wood.
Always wear proper eye and hearing protection when working with power tools.
Total length: 90mm
Shank diameter: 10 x 30 mm
Right hand rotation
Super strength SP steel.
Precision balanced centre point.
2 spurs (V2) : 2 precision ground cutting edges (Z2).