The Miter 5000 blends the incremental angle control features of the Miter 3000SE with a very special 3-panel Sled for the ultimate miter cutting workstation for the table saw.
The Miter 5000 blends the incremental angle control features of the Miter 3000SE with a very special 3-panel Sled for the ultimate miter cutting workstation for the table saw.
The sled can be set up on either the left side or right side of the blade, and a renewable Drop Panel provides zero-clearance tear-out control and cut-off support on both sides of the blade. Two aluminum T-tracks are embedded in the MDF panel top to secure an included work piece hold-down clamp and to provide absolute rigid support for the 36" to 64" telescoping IncraLOCK Cut-off Fence. Will crosscut a 25" wide board with full control on a standard 10" table saw. The Miter 5000 by INCRA delivers perfect, repeatable accuracy.... First time, Every time, Any angle.
Available for standard miter slots and now also for Shopsmith machines! The Miter 5000 is available in a special version to fit Shopsmith miter slots, which are both narrower shallower than 3/8" x 3/4" standard miter slots (use the options selector above). Please note that the Shopsmith version's adjustable miter bar will ONLY fit the Shopsmith 0.719" x 5/16" miter slots and is NOT compatible with the Shopsmith 10ER models or the standard 3/4" x 3/8" miter slots found on most table saws.
INCRA Flip Shop Stop
The Miter 5000 includes our top-of-the-line Flip Shop Stop for the ultimate in repeatable accuracy. The dual-arm design is exceptionally rigid and the arms can be separated and operated independently. The expandable body even allows the use of a wooden zero-clearance sub fence (hardware included!).
GlideLOCK Miter Bar
Six expansion disks adjust both sides of the bar for ZERO side play, anti-friction travel on all table saws with standard miter gauge channels, including Delta, Craftsman, imports, etc. This means that all of INCRA's incredible precision will actually show up in your work because the bar CAN'T wiggle around in the miter slot. The Miter 5000's adjustable miter bar will fit square-sided miter slots measuring 3/4" wide, 3/8" deep, and with or without a 15/16" T-slot at the bottom. The miter bar's adjustment range accommodates actual slot widths between 0.740" and 0.760".
INCRA Hold Down Clamp
Included with every Miter 5000 is this simple and incredibly useful Hold Down Clamp which locks your workpiece onto the sled for maximum accuracy and the cleanest cuts possible. It only takes seconds to use and provides the rigidity needed for world class results.
AngleLOCK Indexing
Precision angle indexing teeth are laser cut in solid steel to lock in 364 positive angle stops in 1/2°, 1° or 5° increments over a full 180° range. it's also continuously adjustable between 1/2° steps.
